Woodworking Talk banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 1 of 1 Posts

·
where's my table saw?
Joined
·
31,479 Posts
good suggestions above

Double then front pieces, eliminate spaces between the joining sections, double the cross brace on the short 30" joint.... and don't locate the seam for the top over the joint. By running the joint into the short section you can take advantage of the strength of the top.

This may not work depending on what your planning for the top covering as a cross seam may not work....I donno? Your assembly process may determine the size of the top pieces and if you plan on disassembly for moving ?


Another idea is to run the top on the short piece across the joint and onto the long piece making the seam there instead. Double the joint pieces under the seam. :yes:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top