Woodworking Talk banner

1 - 1 of 1 Posts

·
Registered
Joined
·
239 Posts
Discussion Starter #1
Last week, I installed the new blades on my jointer.....could not find the depth setting gauge, so ordered another from Grizzly....received it yesterday...this morning, I set the blades, and reset infeed and outfeed tables, and ensured fence was 90 deg. to table.....it is amazing what a huge difference, new blades and a tune up will do.....I know this seem like a "well, duh...", post, but, it only takes a few minutes to make everything right.....happy, happy.....:yes:
 
1 - 1 of 1 Posts
Top