Woodworking Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
271 Posts
Discussion Starter · #1 · (Edited)
While i was working cutting with my jigsaw.I must admit i force my jigsaw in to dryed oak.It was thick 2 inch.Now i have problem my jigsaw dance. Bearings that goes inside in housing has been lost..The jigsaw work good.But it dance in plastic housing.Is dangerous to work with this tool. The bearings are barrel shaped.It make a lot's of noise when tool is turned on.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top