Woodworking Talk banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
During a recent move, the removal company somehow managed to cause this damage to my murphy bed.
Wood Rectangle Flooring Beige Hardwood Grey Wood Natural material Bedrock Rectangle

Under normal circumstances there would be these fittings:
Water Wood Gadget Gas Circle Water Wood Gadget Ceiling Metal

Which slot into the bedframe here:
Property Wood Motor vehicle Line Red

The two damaged attachments should fit to the bed here:
Window Rectangle Wood Shelving Interior design

my question is whether it would be possible to repair the two damaged sections & if so, what would be the best approach.

Thank you in advance for your advice.
 

·
Registered
Joined
·
27,574 Posts
It would never stay if it was repaired. That part of the bed is made out of particle board and has had threaded inserts ripped out of it. The entire panel really needs to be replaced, preferably made out of plywood rather than particle board. If the bed is fairly new see if the manufacturer has a replacement panel and get the removal company to foot the bill.
 

·
Premium Member
Joined
·
1,893 Posts
it may be possible to have a section of flat bar cut and threaded - ca. 6-7 mm thick - and use a slightly longer bolt.
the flat bar could cover/reinforce the damaged area.

the question would be if there is sufficient space/room to do that.
 
1 - 4 of 4 Posts
Top