setting up a shaper knives
Here's what I did when I had my 4". Took a piece of ply and clamped it to the infeed table, close to the head. Took a horseshoe magnet any layed it across the cutterhead. Slip in the knife, jibs etc and put it so the knives contact the magnet. Mark the magnet and tighten the knife in. Do it with the other 2 knives
Paul
Here's what I did when I had my 4". Took a piece of ply and clamped it to the infeed table, close to the head. Took a horseshoe magnet any layed it across the cutterhead. Slip in the knife, jibs etc and put it so the knives contact the magnet. Mark the magnet and tighten the knife in. Do it with the other 2 knives
Paul
