I am trying to install Accuride vertical full drawer slides. I've read the other responses but remain confused (my common state of mind.)
I'm worried about the width of the drawer being too wide or too narrow. The part of the slide that screws into the cabinet wall: the holes are drilled in U shaped tabs. Is that design so you can bend them out if the drawer is, maybe, a 1/16" too narrow?
I understand I need 1/2" on each side of the drawer to accomodate the slides but is there any room at all for error?
I'm worried about the width of the drawer being too wide or too narrow. The part of the slide that screws into the cabinet wall: the holes are drilled in U shaped tabs. Is that design so you can bend them out if the drawer is, maybe, a 1/16" too narrow?
I understand I need 1/2" on each side of the drawer to accomodate the slides but is there any room at all for error?
