Woodworking Talk banner

Inlay Help Now... Contingency Up!

1163 Views 4 Replies 4 Participants Last post by  Quickstep
So I did an inlay using some curly maple with padauk for the inlay. I used a vector laser cutter to cut the template in both. I did the wood whisperer inlay method with the 1/16" bit. During the planing of the final product, a chunk of the padauk came out. AHHH!

I can just go back and route out the original pattern, but what could I put in there? I have some epoxy, and I was thinking about mixing in some of this, that, whatever. But I've never done it. I spent some time on that fleur de lis and i'd hate to junk that piece of maple. Its quite nice.

Ideas anyone?
1 - 1 of 5 Posts
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.