Woodworking Talk banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 2 of 2 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
I have the incra miter gauge with telescoping fence.... Not sure the model number off hand.... I am making plywood boxes for cabinets .... The cabinets I am on now are 12" deep and 30" long.... Should I use my incra to do the crosscuts or make a crosscut sled? They will fit on the gauge with the flip stop.... What would be the pros and cons of using the miter gauge vs crosscut sled? I am going to build a sled but do I need to stop my project to do so?... Thanks guys
 

·
Registered
Joined
·
39 Posts
Discussion Starter · #5 ·
Bill I looked and mine is the 1000se also.... And it is like .002 from perfect.... Lucky really.... I used the 5 cut and determined this
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top