Woodworking Talk banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I am NOT a woodworker, I'm a disabled, R/C Model Airplane builder. I need to make 2 (maybe 4 since I screw up a lot) 1/4"x6" Quarter round sticks.

I'm willing to cut them myself but I don't know what kind of router bit I need. I'm looking for a little bit of guidance and help here. I already have a couple of routers so I just need the bit.

Since I'm disabled (massive stroke) and have only 1 good hand I'm willing to pay someone to help me by cutting these for me. I can even supp;y the balsa wood.

If someone would advise me on the router bit I'll give it a go.

David
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Tried Xacto & sandpaper

Tried the sanding route but with only 1 hand (and my left-hand at that) it came out quite uneven to say the least.

I know enough about woodworking "stuff" that I figured I'd need a routing table but I didn't think about feather boards.

Thanks for your help, I guess I'll have at it the first of the week.

David
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top