Woodworking Talk banner
1 - 1 of 1 Posts

· Registered
Joined
·
13,782 Posts
Drill the hole with the size indicated on the extractor, insert the extractor into the hole, extract screw by turning the extractor with a tap wrench or crescent wrench.
Yes, it is that simple. The most complex piece of work is selecting the correct size tap.

You will need a new/sharp drill bit. It may be necessary to "tap" with a hammer the tap wrench into the hole.

George
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top