Woodworking Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
364 Posts
Discussion Starter · #1 ·
I made this box joint jig a while ago when I thought I was going to need the large 3/4" size. I would like to keep the sled part and convert it to a smaller size like something between 3/8" and 1/2". I'm not exactly sure how to go about this. I think I change the key and then relocate it on the sled? Maybe change out the backer board? What do I do first? Any tips or hints etc. would be appreciated.



I realize I can go to youtube but there if you watch 3 or 4 videos of someone building a box joint jig, you end up with 3 or 4 different ways to do it.....
 

·
Registered
Joined
·
215 Posts
I think relocating it to another part of the sled would end up costing you some stability in the sled. I would think just adding a new fence in front of the current setup would get you to where you want to go. Looks like you have plenty of space.

Regards,
Steve
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top