Woodworking Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
77 Posts
Discussion Starter · #1 ·
Hello everyone
Here is a quick tip on how you can modify the pulls in the Hardware pulls library that eCabinets has available.
Today I came across a situation where I need a pull for some lid supports on a secretary stile desk that I am drawing. The pull that I need is ½ inches in diameter. The pulls that eCabinets has in the hardware pulls library were too large for my application. I would like to show you how you can change the sizes and save them so that they can be applied to your doors and/or drawer fronts.
Here is the link to a video that I made on how to do this. Check it out and let me know what you think.
http://youtu.be/0L1ebY-mX_8
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top