Woodworking Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
303 Posts
Discussion Starter · #1 · (Edited)
Solved..



Anyone have one of the Ryobi Miter saws ? I have the 1346 TL and cannot for the life of me adjust the bevel from O degrees.

I am following the owners manual step by step. No dice.

The only thing I can figure is the lock pin only comes out about an 1/8" and the saw doesn't raise any higher than the normal.

Solved it.

Well, I sprayed some WD40 on the contact surfaces and played around with it.
Finally got it working. Had to spin the miter adjust over to the 45 degree mark and then it just magically allowed me to adjust the bevel.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top