Woodworking Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5,639 Posts
Discussion Starter · #1 ·
I started a drawing with the default settings which were Ft./In. and now after I’m almost done, I want the dimensions in inches only.
The only place that I found to do it is in the ‘Template’ tab under Preferences, but it doesn’t work and I don’t want to start over again.
Can anybody help me?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top