Woodworking Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
I wanted a small block plane and although I have a couple of small block planes I wanted on that was a little smaller so rather than pay out for an expensive one I thought I'd make one myself. I also thought I'd utilise my 1" chisel as the blade. I used left over off-cuts of some Jarrah that I had. It was pretty easy to make and the shavings I have got so far are nice and clean.





 

·
where's my table saw?
Joined
·
27,870 Posts
pretty cool

It has a built in but removeable handle. Now when you can't find your 1" chisel look on the plane shelf. :yes:
 

·
Registered
Joined
·
15 Posts
Discussion Starter #4
Hi Tim, the angle is 25°. I think I will make a couple of them at different angles. 20° and 15° would be good. The first one only took about an hour to make and I still have some of the Jarrah off-cuts left over.
 
1 - 4 of 4 Posts
Top