Woodworking Talk banner

1 - 1 of 1 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter #1
I have two delta "shaper routers" that I love. I finally finished my setup in the shop where one is dedicated to rails and the other stiles for raised panel doors so I never have to change bits. I run freud 1/2" router bits in both of these. here's the catch...I picked up a shopfox mini shaper on ebay, and its a little more mini than I was expecting. It accepts only 1/4" router bits or 1/2 shaper cutters!

is there anyway to stick a different collet in it to accept 1/2? I was going to use this machine to raise panels on, or would it be easier to just put a cutter on it?? I've looked everywhere but cant find any 1/2" collets that say they will work. I could switch everything around and use it for something else but I already have everything set up the way I want it. thanks in advance for your help!!
 
1 - 1 of 1 Posts
Top