Joined
·
32,681 Posts
if it were me
I'd make the layout lines on the back side, turn it over and use a circ saw set at about a 20 degree angle from vertical, and saw to the lines....you can use a straight edge guide clamped in place for better/straighter cuts. You have to allow for the offest from vertical....probably about an inch or less and make your layout oversize....I'm just spitballin' here...guessin' UNLESS those dimensions are the bottom and the top can be whatever it turns out?
Is this a glue up? How thick? :blink:
I'd make the layout lines on the back side, turn it over and use a circ saw set at about a 20 degree angle from vertical, and saw to the lines....you can use a straight edge guide clamped in place for better/straighter cuts. You have to allow for the offest from vertical....probably about an inch or less and make your layout oversize....I'm just spitballin' here...guessin' UNLESS those dimensions are the bottom and the top can be whatever it turns out?
Is this a glue up? How thick? :blink:
