[Rebelwork]

Here’s something to keep in mind when making these. The 1/8x3/4 bought was a different width. It was a little bit wider than 3/4.

 

[Rebelwork]

A lot of people use wood..

 

[Rebelwork]

As you can see the rack holds 85 cam clamps 8" or smaller.

 

[Rebelwork]

The clamp rack is 19.5 wide x 16” deep x 28” tall when filled..

smallest clamp rack I got in the shop that holds plenty..

 

[Mud]

I have 2 of each size of these clamps from HF. I clamp them to a saw horse and use them to hold panels vertically. Works well and zero issues in the 3+ years I've had them. Recommended.

 

[Rebelwork]

I think I will re paint the clamp holder. Red is over powering my shop…

Red is like kryptonite in my shop..

 

[Rebelwork]

So the HF and Menards wood screw clamp have problems. Because of the way a couple HF clamps were difficult to turn and the Menards clamps were jamming, I wonder if a little work with a fine wire brush on a drill would help?

 

[Leo G]

I have about 6 of the 12" HF clamps and each one is fine. I make sure I run them through the threads before I purchase. Don't recall finding any sticky ones while testing. For a while every time I went in the store I picked up one. I have enough of them.

 

[Mud]

So the HF and Menards wood screw clamp have problems. Because of the way a couple HF clamps were difficult to turn and the Menards clamps were jamming, I wonder if a little work with a fine wire brush on a drill would help?

Hmmm, I have 6 of the HF clamps and do not have any issues whatsoever. I would return them for new ones since they have lifetime warranty.

 

[Rebelwork]

I was just going to order them, but says ”in store only”