Woodworking Talk banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 1 of 1 Posts

·
Registered
Joined
·
1,010 Posts
In the past I've gotten the best looking results by cutting (with a good quality thin kerf table saw blade) the top and bottom frame parts away from the center, then cutting the drawer face(s) from the center section. Glue what is left of the center section to the top and bottom rails and you'll have a perfect square opening for the drawer face. Start with a board oversized by the saw kerfs and any jointing you'll be doing to the parts. You'll need to trim the drawer face a little to clear on top and bottom edges.

4D
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top