Woodworking Talk banner
1 - 4 of 4 Posts

·
Registered
Joined
·
535 Posts
Discussion Starter · #1 ·
I just bought this awesome countersink bit from Harbor Freight Tools.

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=95937

I has a depth stop that will not mark up your wood. I used it today for the forst time on a project and I can't tell you how much time it saved me. The depth stop gives you a consistant depth every time without the trial and error. Very nice for a project where you have a lot of countersunk holes.:thumbsup:
 

·
Registered
Joined
·
33 Posts
Hi Ken was just looking at the same bit did not know how it would work
thanks for the info. I am from Pa. to up by Scranton/Wilkes-Barre

Joe
 

·
Woodworking Firefighter
Joined
·
513 Posts
Hey Ken, go ahead and buy you a back up just like it. Ive gone through 3 of them now b/c they keep breaking on me. (Could be operator error):blink: Other than that, yeah they work fairly good.
 
1 - 4 of 4 Posts
Top