Woodworking Talk banner
1 - 1 of 1 Posts

· Registered
Joined
·
23 Posts
I didn't catch if you had a table saw but I'm going to assume you do. It can be done without one but is a little more involved. One way I've found to eliminate squeeze out if you must is to saw a groove in your piece just outside of where you will apply glue and it will capture the glue and be hidden within the joint. Doesn't work well in every application but has served me well in a few spots. Good luck!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top