Woodworking Talk banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,151 Posts
There are lots of glue spreaders out there, ranging from rollers to brushes etc. Personally I use a plastic squeegee intended for spreading Bondo. Always have a damp rag handy when gluing up, and wipe squeezeout before the glue sets. Then come back in about 20 minutes and look for any you missed - at that point glue will be soft enough to remove with a scraper.

I have built birch ply book cases and done what you propose, but using small brads (and glue) to hold the thin strips on. I just set them below flush and filled the holes with a wax crayon the same color as the stain. Minwax makes them.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top