[cabinetman]

The cut off nail method works for some procedures, but I wouldn't use it for ¼" edging. For ¼" thick edges, I would use a thicker strip (between the clamp end and the edging) to dissipate the clamping pressure over a wider area than just a clamp end.

You could use an "acid brush" for spreading a thin layer of glue on both surfaces. I wouldn't make the application heavy, but have the surfaces covered. If you get squeezeout, use a wet rag to wipe it clean.

.

 

[cabinetman]

You could just use TB I, or TB II and apply a thin layer of glue to both parts, and tape the edge on.

.