Woodworking Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
371 Posts
Discussion Starter · #1 ·
I was using my shaper and realized that the bit had dropped in my last few pieces. I have the lock on but can still turn the shaft up and down. don't know if this is normal or not.
 

·
where's my table saw?
Joined
·
28,746 Posts
no, not normal

The lock knob is not functioning, part number 128 in the PDF diagram:
http://cdn0.grizzly.com/partslists/g1026_pl.pdf

See if it's screwing all the way in, against the gib bar or if there is something missing etc. Mine locks OK. I don't know what else it could be? Unless your arbor is not firmly locked down, but that would be remote ..... and dangerous. :eek:
 
  • Like
Reactions: Kevin07
1 - 3 of 3 Posts
Top