Woodworking Talk banner
1 - 4 of 4 Posts

110 Posts
Discussion Starter · #1 ·
Today I bought a new blade for my table saw. My previous blade was a B&D Piranha 24T. When it was sharp... it seemed to do an ok job. The replacement is the Freud 10" 50T Combination blade LU83R.


WOW! What a huge difference! I was not expecting this much of an improvement but I was blown away. I've only made a couple of cuts with it so far, but it's night & day difference.

If you're still using the 3-pack B&D from Lowes and keep buying them cause their cheap... STOP! Invest in a decent blade! In fact, I would suggest starting with the LU83R as a general blade.

Next I'm going to put a quality crosscut blade on my miter saw and realize that machines potential.

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.