Woodworking Talk banner
1 - 1 of 1 Posts

· Registered
Joined
·
303 Posts
There's no build thread for this particular one, I had never done one before and basically just "winged it". This one was done with an older 14" powermatic saw with a dull 3/8 blade. The blade was a little wide to make the tight curves I wanted so a 1/4 blade should work fine. Go for it!
Get a Carter stabilizer and a decent blade.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top