Woodworking Talk banner
1 - 20 of 22 Posts

· where's my table saw?
Joined
·
32,292 Posts
Well done! Great job. Looking forward to the finished pics
I'll second that! Very nice job and a large project to boot.
I don't know if that dust on the floor matters with the Graco airless?
I'd vacuum it just to make sure.
 
  • Like
Reactions: Miket

· Registered
Joined
·
42 Posts
looks great. lumber jocks has the same format used here and they have a (progects in progress) section and something called (journals) thats used as a place to post blogs.i dont see that here though ?
 

· Registered
Joined
·
61 Posts
Discussion Starter · #11 · (Edited)
1st coat of paint was a disaster.
Poor lighting gets you in trouble fast with that airless. Lol
Had a few runs.

Worked for the best. Sanded it back smooth and hit it with an acrylic primer first this time as I had some bleed through on a couple doors.
3 top coats with adequate lighting and I am happy with the results.

Tomorrow the tops
 

Attachments

· Registered
Joined
·
62 Posts
1st coat of paint was a disaster.
Poor lighting gets you in trouble fast with that airless. Lol
Had a few runs.

Worked for the best. Sanded it back smooth and hit it with an acrylic primer first this time as I had some bleed through on a couple doors.
3 top coats with adequate lighting and I am happy with the results.

Tomorrow the tops
They look great. Keep the pics coming.
 

· Registered
Joined
·
61 Posts
Discussion Starter · #16 ·
It will be covered in epoxy, edges sealed, so water shouldn't be an issue.
If it does eventually fail we will just redo it.
No dishwasher or anything that will create moisture from underneath so I'm hoping for the best but we are prepared for the worst. 👍
 
1 - 20 of 22 Posts
Top