Woodworking Talk banner

1 - 6 of 6 Posts

·
Newbie
Joined
·
5 Posts
Discussion Starter · #1 ·
I've just finished a coffee table for my son's first off-campus residence. The primary reason for the table is to serve as a canvas for a design to be created using beer caps that I've been saving for years. (OK, decades. I have a lot of beer caps... more than he'll use for this little table.) The plan is to embed the bottle caps in epoxy. To that end, I recessed the plywood table top about 3/8" so that the finished surface will be at the top of the surrounding frame. He'll glue the bottle caps down, then cover them with the hi-build epoxy.

Two questions:
First, does anyone have experience with using a hi-build epoxy finish in this way?... if so, do you have any advice for techniques or things to watch for?
Second has to do with finishing everything beyond the table top. I've had in mind that we'd just use the epoxy to finish the rest of the western red cedar frame and the lower plywood shelf. Is that a reasonable idea?... does the cedar require any special preparation?... or will it take the epoxy directly?
 

Attachments

·
Registered
Joined
·
49 Posts
It's going to be a lot of work coating the legs and sides of the table with epoxy.You may want to see how the top come out first.I haven't worked with the stuff you mentioned.But if its anything like mirror coat do a seal coat first and pay attention to the temp when you go to mix about 70 is best.Bubbles pop with a propane torch.
Sounds like a great project hope it comes out nice and good luck.
 

·
Newbie
Joined
·
5 Posts
Discussion Starter · #3 ·
Thanks, Backb. Good suggestion to wait & see. I'll just have to be careful around the rim.
 

·
Registered
Joined
·
3,214 Posts
they make a 2 part "bar top" surfacing product that is sold in our local hardware stores that may work well for your application. it results in a very thick finish. fyi... i haven't used it personally.
 
1 - 6 of 6 Posts
Top