[fire65]

Finally got them done and tops installed. I posted the build of the tops a while back. Thank for looking. Suggestions are always welcome.
Did not know there was a limit on pics. Continued

 

[davidbard]

nice job

 

[Chris Curl]

looks great. for the floor to ceiling cabs, how do you get them through the door and then straighten them up without hitting the ceiling?

the limit is on how many pics in one post. for more pics, you can just do another post in the same thread. you don't need to start a new thread.

 

[fire65]

looks great. for the floor to ceiling cabs, how do you get them through the door and then straighten them up without hitting the ceiling?

the limit is on how many pics in one post. for more pics, you can just do another post in the same thread. you don't need to start a new thread.

LOL, spent a lot of time thinking on this. I built jigs and took them to the house, saying how tall can I build this. YES, I said I will build 4 inch spacers and just raise them up and set them on this. That did not work.
Then I said to me, AH HA, I have room for crown at the top, I use 4" solid for my top face to allow for crown.
Now I just split my cabinets, usually at 35" depending on where they go. Usually I can hide the line, If not I build the faceframe a little over and add 1/4" plywood over the side if there is no way to hide it.
I do like you asking, as I did to a few fellow cabinet makers. NEVER heard a really good idea.
ANYONE GOT ONE, PLEASE, share it.
E
E

 

[Travico]

Where were you when I needed my cabinets built? Those look great!!

 

[MagGeorge]

Fantastic cabinets! Like the great design, has clean lines and looks very professional. Great to see them installed, very well planned. Impressive work!

 

[Fred Hargis]

Nicely done, I may be facing the same job. If so, I hope it turns out 1/2 as good as yours!