Woodworking Talk banner
1 - 1 of 1 Posts

· where's my table saw?
Joined
·
32,680 Posts
I can't quite picture this...

Can you post a picture? Regardless, using biscuits on a 30 degree miter may prove difficult. A full length spline would be better and easier in my opinion. IF you have a good means of securing the boards at that angle, you don't even need a spline. You just don't want the edges to slide as you apply clamping pressure.

You may have to fab up a jig to make the clamping go well....
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top