Woodworking Talk banner

1 - 2 of 2 Posts

·
Trees to Art
Joined
·
24 Posts
Discussion Starter #1
Here is what I finally came up with for a Walker-Turner bandsaw. I cut off part of a plumbing "j-trap" and cut the clearance slot on the table saw. The wood that fits in the cast webbing has flat magnets epoxied to hold the whole assembly in place. Hooked up to a shop-vac. It is VERY efficient. NO dust left to enter the wheel housing!
 

Attachments

·
Registered
Joined
·
387 Posts
Here is what I finally came up with for a Walker-Turner bandsaw. I cut off part of a plumbing "j-trap" and cut the clearance slot on the table saw. The wood that fits in the cast webbing has flat magnets epoxied to hold the whole assembly in place. Hooked up to a shop-vac. It is VERY efficient. NO dust left to enter the wheel housing!
Whatever works for ya bud. Looks good IMO!
 
1 - 2 of 2 Posts
Top