Woodworking Talk banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am working on a project were I have a 5 foot wall that would be at a 90 degree angle except it protrudes into a walkway so I had to make the corner, of the wall, a 45 degree wall. For the oak boards on the top of the wall cutting them for the 45 degrees would be a breeze accept the top is also at 45 degrees vertically (to keep things from being set on it). As I am doing the top in oak the boards are not cheap so while I can make allowances for a minor mistake, a major miscalculation may require a new board.

So how would one cut a board that needs both a horizontal and a vertical 45 degree angle?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top