Woodworking Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
404 Posts
Discussion Starter · #1 ·
Not thinking straight today or this week perhaps. I've got 22 upper cabinet doors to make of which only 5 are the same width. I need to put arches in the lower rails( see lovely image). I could make 17 templates, but is there a much simpliar way that I'm just not thinking of? Shaper with pattern bit.

Pattern Text Pattern Design Diagram
 

·
Registered
Joined
·
404 Posts
Discussion Starter · #3 ·
Right, but I'm looking to do away with templates if possible. I know it can be done, just can't wrap my head around the setup.
 

·
Registered
Joined
·
404 Posts
Discussion Starter · #6 ·
Didn't think if that Steve. You are right. Ill make 3 and let the flat vary. It will be minimal/passable differances. Thanks
 
1 - 3 of 3 Posts
Top