Woodworking Talk banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 2 of 2 Posts

·
Registered
Joined
·
293 Posts
Discussion Starter · #1 · (Edited)
Well, when making another end grain cutting board I ran the end grain through my planer. It was done very little at at time, just so I could hear the getting hit. The edges were hit up very little, but I'll be routing those. So it worked pretty good. Does anyone out there think I'm crazy for doing that?

Eric Williams
 

·
Registered
Joined
·
293 Posts
Discussion Starter · #7 ·
sawdustfactory said:
I've read where someone was badly injured when an end grain chunk tore loose and caused catastrophic failure of the planer sending shrapnel into the user.
I don't like hearing things like that but it is very important. Thank you.

Eric Williams
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top