Woodworking Talk banner

Delta model 10, 34-429 blade lowering

2K views 3 replies 3 participants last post by  rdhart 
#1 ·
I have a Delta model 10 table saw (also a Delta Unisaw). The model 10 blade won't lower all the way below the table. It lacks a 32nd or so. If it were turned on with something laying on the blade it could be a problem especially if it were a hand. I always keep my blades lowered all the way when not in use for safety. Does anyone know a fix for this problem? Thanks
 
Discussion starter · #4 ·
Delta 34-429

Thanks for the help. I have not taken time to clean the saw. I have heard or read somewhere that there is a design problem with this model that prevents lowering the blade all the way. Thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top