Woodworking Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I need some help. I inherited a Delta 34-441 10” table saw from my grandpa. It has been sitting for quite some time. I have discovered that both capacitors are bad. There are no markings on them so I’m not sure what I need to get to replace them. The motor is a Delta 62-044. 1 1/2 hp. I have tried contacting Delta but still haven’t gotten a response. I am just hoping maybe someone else on here has replaced them. Any advice or tips would be appreciated!
 

·
Registered
Joined
·
299 Posts
It looks like someone else had the exact same question last year. Take a look at this thread:
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
It looks like someone else had the exact same question last year. Take a look at this thread:
[/QUOTE

Thank you so much! That is exactly what I needed. Now the search is on!
 
1 - 3 of 3 Posts
Top