Woodworking Talk banner
1 - 10 of 10 Posts

·
Registered
Joined
·
242 Posts
Welcome, that is not much info to go on. Might try an introduction and some pics or sizes of what you are working on.
 

·
Registered
Joined
·
27,647 Posts
The deck spindles are normally put in the hand railing where they are toenailed in. If they are metal spindles sometimes they are mortised in by drilling a hole. If you could show us what you are working with you might get a more specific answer.
 

·
Registered
Joined
·
3,339 Posts
You can add photos as attachments to your posts.
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #8 ·
the 2x4 is routed through with spacer pieces bewtween the posts how do i make this cut into the 2x4 and make the spacers
 

·
Registered
Joined
·
244 Posts
the 2x4 is routed through with spacer pieces bewtween the posts how do i make this cut into the 2x4 and make the spacers
+1, this is the easiest way of doing it. A downside of doing this is that it is noticeable unless one is careful in picking out the grain of the spacers so they match the dado'd 2x4.
 
1 - 10 of 10 Posts
Top