Woodworking Talk banner
1 - 1 of 1 Posts

· Registered
Joined
·
13,746 Posts
That is very ingenious. However, I would just suggest that you set your saw at 22.5 deg.

Put a scrap board on your saw and set your saw to 22.5 deg. Saw the board in two. You will now have two boards. Each will have one angle that is 22.5 deg and one that is 67.5 degree.

George
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top