Woodworking Talk banner
1 - 5 of 5 Posts

·
Registered
Joined
·
225 Posts
Discussion Starter · #1 · (Edited)
Cutting one straight edge on table saw

Good day

I wold like to share with you my method of cutting straight edge on the table saw.

I used a little bit different method (to my knowledge) and I hope you will find it helpful.

Regards
niki

















 

·
Registered
Joined
·
26 Posts
Great idea. But isnt there a chance the board could tip if the pressure is applied in the wrong spot?
There should be a forum for Jigs.
 

·
Registered
Joined
·
225 Posts
Discussion Starter · #4 ·
Thank you so much

Frosty
You are correct, that's the reason the trowels are positioned some 5~6" from the blade so I always will press on the "correct spot".

I have another, narrower board but it was too narrow for those 8"~10" wide boards.

About jigs forum...that's why I post all the jigs on this forum so it will be easy to find them later...

Regards
niki
 
1 - 5 of 5 Posts
Top