Woodworking Talk banner
1 - 6 of 6 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
Got the chance to spin my big Fay and Scott lathe the other day for a custom rosette job and six tricky staircase spindles.
Rosettes were spun 4 at a time on the faceplate to achieve the offset curved profile to match the casings.

Spindles were turned on my smaller Delta lathe.

Check it out:








 

·
Registered
Joined
·
1,718 Posts
Outstanding Lob on your turning :thumbsup::thumbsup:
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top