Woodworking Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
110 Posts
Discussion Starter · #1 ·
Has anyone bought the Craftsman ZCI from Woodcraft (#124214)?

Does it have the hold-down clip at the rear?

Also, I noticed from the picture that it does not have the screw slot in the front. Am I supposed to drill this hole, or does it not use the screw?

Thanks
Steve
 

·
Sawdust Creator
Joined
·
8,046 Posts
I stopped buying inserts when I figured out I could make them for about 2 bucks each. If you have a router, a straight bit with a bearing and a stock plate to use as a template your golden.

Pick up some baltic birch plywood and whip out 5 in under an hour.
 

·
Sawdust Creator
Joined
·
8,046 Posts
And for the record.....I didn't answer your question but no I haven't bought any there, and I wouldn't use the front screw....the rear clip is important and I've found that picture hangers can easily be adapted to this use.
 
1 - 3 of 3 Posts
Top