Woodworking Talk banner

1 - 1 of 1 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
Hello,

I inherited a craftsman floor drill press model # 113.213811 and seems to be running pretty loud and rough. There is a little wobble at the chuck but I'm not sure if it's the spindle or not. I plan on replacing the chuck, the quill bearings, the pulley bearing, and the belt with a link belt.

I can not figure out how to even get into this thing because the quill return spring is not on the outside like most drill presses. Any idea where to begin? I'll attach pictures.

Also, any recommendations on a decent chuck that won't break the bank? Under $100.

Thanks,

Zayne


Sent from my SM-G986U using Tapatalk
 
1 - 1 of 1 Posts
Top