Woodworking Talk banner
1 - 10 of 10 Posts

·
Registered
Joined
·
1,341 Posts
Discussion Starter · #1 · (Edited)
This is a job I designed and built last Spring. It is 1/4 sawn red oak done in classical style, complete with secret compartments. The door panels are quarter matched big leaf maple, laminated onto 1/4" oak ply panels. The only thing I did not make myself are the dragonfly plinths. I ordered those online. The printer in the knee hole extends completely out for top access. It is mounted on 2 sets of 22" slides in the manner of table slides, and the tray has casters mounted under it to support the weight when fully extended.
Furniture Room Property Computer desk Cabinetry


Furniture Wood Room Carving Molding


Wood Furniture Wood stain Hardwood Table
 

·
Registered
Joined
·
1,341 Posts
Discussion Starter · #10 ·
Thanks. It was a challenging one. The panels were made from big leaf slabs I got from a local sawyer. I had to cut blocks, re-saw 4 pieces from each block, and run them through a drum sander to get good surfaces. They are about 1/8" thick, and then after laminating , I ran them through a wide belt sander.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top