Woodworking Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I've been kicking around the idea of upgrading my router table that's attached to my unisaw. Has anyone added one to a unisaw? If so, how well does it fit? I dont want to drill holes in the existing top. The one I'm looking at is a Bench Dog. Thanks!
 

·
where's my table saw?
Joined
·
31,234 Posts
Mine's a Bench Dog

I like it just fine. Nice and heavy and a good fence that came with it.
Just know that it is meant to fit up on saws that are 27" front to back. Here it is attached to my multiple saw setup:


 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top