Woodworking Talk banner
21 - 25 of 25 Posts

· Registered
Retired
Joined
·
71 Posts
Discussion Starter · #21 ·
Huh? The thread is about treating aluminum, N'cest pas? Hence the question.
 

· Registered
Retired
Joined
·
71 Posts
Discussion Starter · #23 ·
Oh, lol. Thanks for the clarification!

Lyman
 

· Registered
Egg Spurt
Joined
·
3,619 Posts
Is it slotted aluminum? If it is I wouldn't do anything to it other than run it till the blade falls off then buy a cast iron top model. Maybe occasionally run a small flathead screwdriver through the slots and maybe take some fine grit sandpaper to the surface..
 
21 - 25 of 25 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top