Woodworking Talk banner
1 - 1 of 1 Posts

·
Senior Member
Joined
·
7,222 Posts
I only use MDF for jigs.

You could use plywood and 3in nose as you mentioned, but may look odd.

You could rip 1/8in strips of walnut and laminate a nose. You may see the lamination.

As Phaedrus mentioned, perhaps easiest solution is to make the top out of solid walnut. Does not need to be 2in thick. 5/4 walnut should be more than adequate. 3 @ nominal 6in wide boards should work. 2 @ nominal 8in wide boards will be 14 1/2in wide.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top