Woodworking Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter #1
I just got about a dozen pins from a buddy of mine. I can still get more. I need to figure out how to strip them and i need ideas on what to turn them in to. Anyone have any easy methods of stripping the plastic off these things?
 

·
Registered
Joined
·
95 Posts
A suggestion find the center of the bottom tail stock end and put the top in a jam chuck it need not go in more than 1/2" as the whole piece would be held by friction.Then turn off the plastic. Make salt and pepper grinders, mallet and coffee mug.
For the grinders try crush grind bottom fit it is the one with no shaft and you could make it back to a bowling pin s/p grinder. pm if you have questions.
Regards Roger C
 

·
Senior Member
Joined
·
7,222 Posts
1 - 4 of 4 Posts
Top