Woodworking Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
HELP
am trying to bend cork 3/16 thick by 1 3/4" wide on the flat for
my model rr to form curves of 22" and 18" radius
sny help would appriecated.
thanks
phil
 

·
Registered
Joined
·
1,112 Posts
Phil
My experience with laying cork beds is to trace your route lines and then use a contact cement and straight pins to hold it in place until the glue has a chance to set.
Haven't built any in some time but hope to soon.
 
1 - 3 of 3 Posts
Top