Woodworking Talk banner
  • Hello Everyone! Let us know what you would spend a $50 Amazon gift card on, HERE For a chance to win a $50 Amazon Gift Card!
1 - 1 of 1 Posts

·
Registered
Joined
·
213 Posts
cabinetman said:
Just glue and clamps will work.






.
+1

I wouldn't buy a special bit for it for sure, plenty of glue to saturate the end grain of the ply and plenty of clamps will make a clean strong joint. If you have a biscuit jointer you could use that, if only to help with alignment.

With that said the type of router bit posted is a good one to have in the shop, though Id save up and get a better brand. Rockler bits are ALWAYS the first ones to wear out in my shop.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top