Woodworking Talk banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,895 Posts
Discussion Starter #1
I bought a nice used vertical panel saw that uses a 8" blade.
Having a hard time locating a fine finish blade. I don't have the orig blade, but I assume it is a neg. hook. Does anyone know if a neg hook is recommended?
 

·
Registered
Joined
·
1,895 Posts
Discussion Starter #3
I should have mentioned, that I was looking for a blade at a "decent price". $150, for an 8" blade. Not
 

·
where's my table saw?
Joined
·
28,567 Posts

·
Registered
Joined
·
1,895 Posts
Discussion Starter #5
It's designed for a 8" blade. The po bought it, and just used it to cut lexan shutters, and put a 7 1/4, 60 tooth blade on it.
I haven't been able to try it with that blade, because there isn't room in the shop for it, and it's currently buried on the lanai. Just trying to find a great blade for it, so when the time comes, I have it on hand.
I hope to be able to tune it, to give accurate cuts for making cabinet boxes.
 
1 - 5 of 5 Posts
Top